The best, my 2nd pair.

I put 2 of these on the front with the stock springs. Car rides great now, but here are the steps to install these so you can decide if it's worth it for you: -Remove wheels -unbolt brake line and speed sensors from strut -remove tie rods -remove 2 main strut bolts -pop hood and remove the 3 strut mounting bolts -pull out strut from car -use spring compressors on the springs -remove bolt holding strut together -pull out strut from the springs -drill a hole in the center of the top of the strut housing using 1/4 inch or smaller drill bit -drain strut fluid -mark a spot to cut the strut, 40mm from the bottom of the strut housing (instructions say subtract 6mm from the length of koni yellow bottoms to the portuding bumps on it which is 46mm in this case) -use tape to wrap around the strut on your mark to use as a cutting guide -cut off the strut housing with a saw on your marked spot -pull out oem damper -file down the edges on your cut -use 1/2 inch drill bit to widen the hole on top where you drained the fluid -insert koni yellow into your modified strut housing -use provided bolt in packaging and put through 1/2 inch hole on top and thread into koni -use ratchet to thread bolt to pull the koni all the way into place -remove the bolt and re thread it in the same spot with the provided crush washers -re install into your springs and put back in car And voila youre done. 12 hours later and 3 trips to auto zone and you should be finished. Maybe consider buying a fully assembled strut if that sounds like too much.

Paired this with the Eibach prokit. I have them adjusted about 3/4s to full firm. Ride quality is great. My car is a dd and it's very comfortable. It's perfect for how I want it. Props to kseriesparts for exceptional service and fast shipping. I'll definitely be ordering from here again.......well I already have. Lol. Thanks for everything guys.

I love my Koni Yellows, they are a terrific ride for my daily commute, where the roads are not exactly smooth. Paired with eibach springs, the ride is smooth enough to be usable and practical, while retaining good handling for the twisties.

these shocks are design for all of the lowering springs. I love them even we have to the mod for the front shocks on rsx. I would suggest these shocks for people who only have the lowering spring and don't have the koni yet. Great handling and comfort. Prebound is adjustable. By the way, the shipping package is missing the 2 plastic nuts that prevent from bottom out for the front shocks were missing. Other than that, i have nothing to downgrade for these shocks.