Images may be for reference only
Product Details
| Part Number: | KTD-RCA-R05 |
| Brand: | K-Tuned |
| Location: | Front |
Application: 2005-2006 Acura RSX (Doesn't fit Type R)
- Roll center adjusters help to maintain proper steering alignment and suspension geometry on lowered cars.
- If you have lowered your car these are a must have to keep it handling the best.
- Replacing worn bushings and suspension components can really make an older car feel new again.
- Sold in pairs
WARNING: This product may contain chemicals known to the State of California to cause cancer or birth defects. www.P65Warnings.ca.gov.
Vehicle Fitment
| Year | Make | Model | Trim |
|---|---|---|---|
| 2005 | Acura | RSX | Base |
| 2005 | Acura | RSX | Type-S |
| 2006 | Acura | RSX | Base |
| 2006 | Acura | RSX | Type-S |
8 Reviews ★★★★★
0
0
0
2
6
5 Most Recent
Read All 8 Reviews
Read All 8 Reviews
Ralph Muniz | October 10th, 2025
Threw these on my old dc5. Bought a new dc5 that came with them already. Beat on both sets for thousands of miles, never broke or failed. Now I’m ready to replace the current set because one of the boots is finally torn. They stood the test of time and never left me stranded. Not many people drive the rsx as hard as I do so I will be repurchasing these. 5stars hands down.
Sean Shadrick | July 11th, 2024
Arrived quickly, great quality and easy to install.
Len T | February 27th, 2023
So far with the new ball joints feels great sturdy , stiff matched it with the ktuned lower control arms
Juan Silva | July 9th, 2022
Installed my new K Tuned Roll Center Roll Adjusters ball joints along with Koni struts and they are working great
Stetson | July 20th, 2021
Finding standard ball joints for the 05-06 RSX at the local parts store was a lost cause, so was finding a part number online. So I figured why not go with an option that helped correct suspension geometry after lowering the car, AND the pair cost less than the one single replacement option I found. The only bad thing I have to say about them is that the little K-Tuned banner around the circumference is a poor quality sticker that didn't survive installation, much less do I have any confidence that it would survive life under the car for long (but at least now I have a fuzzy white band of paper stuck to the ball joints until that wears off, that's cool too, right?)
