Images may be for reference only
Product Details
Version 2 of the Rywire K-series Milspec Engine Harness was created to facilitate a more universal chassis, and harness routing preference. This style can be routed more like the OEM k-series engine harness through the center or more to the right on the firewall than it's Version counterpart. This routing method is ideal for our (RHD) Right Hand Drive customers however NOT exclusive to RHD chassis and does work fine on a LHD chassis.
Harness Connector List:
- VTEC solenoid
- VTC
- Oil pressure sending unit
- Crank Sensor (02-04 K20 style)
- Coils 1-4
- Cam
- Top Dead Center sensor (TDC)
- Engine Coolant Temp (ECT)(02-04 K20 style)
- Knock Sensor (KS)(02-04 K20 style)
- Intake Air Temperature (IAT)
- Alternator
- Manifold Air Pressure (MAP)
- Throttle Position Sensor (TPS)
- Idle control motor
- Electronic speed sensor (VSS)
- Injectors 1-4
- h20 sending unit (for gauge cluster)
- Reverse Lights
- Reverse Lockout solenoid
- Starter signal
- ECU plugs A and B
- Power distribution cap
- Ground
- 2 Extra Wires
| Part Number: | RY-K2-MILSPEC |
| Brand: | Rywire |
WARNING: This product may contain chemicals known to the State of California to cause cancer or birth defects. www.P65Warnings.ca.gov.
Vehicle Fitment
This part does not have vehicle specific fitment. Please contact us if you need assistance.
Engine Fitment
| Engine |
|---|
| Honda 2.0L/1998CC - 4 Cylinder (K20A2) |
| Honda 2.0L/1998CC - 4 Cylinder (K20Z1) |
| Honda 2.0L/1998CC - 4 Cylinder (K20A3) |
Reviews
No Reviews Yet!
Write a Review
_220x220.png "K-Tuned Pre-Fit Heater Hoses")
