Free Shipping Over $299.99
Orders of $299.99 or more ship free within the continental U.S.
Shipping to Alaska and Hawaii is additional and not included.
We do not ship international at this time.
Skunk2 K-Series Black 74mm Pro Series Throttle Body Reviews
0
0
0
2
6
Urayoan | August 22nd, 2023
Product worked great with my setup
Drew Vickers | November 14th, 2021
Great craftsmanship, design and quality. Cant wait to port match my manifold and feel the little dragon breathe.
Quinn | September 14th, 2021
Fast shipping, great response from customer service. Packaging was really nice
MJ | August 12th, 2017
I have the karcepts iacv block off plate, and found the perfect length screw when fully tightened the throttle plate is open to the perfect spot. My idle is bang on and when i come to a light and clutch in, it never dips lower than 800rpm, so im very happy with this throttle body now. It took some time to get it dialed in perfectly after a lot of trial and error. Used to think the throttle plate would stick, but wasnt the case. I just didnt have it set up properly. ALL IN ALL GREAT DRIVEABILITY NOW :)
Mike | September 10th, 2012
Installed this along with the Skunk2 Intake Manifold for a whopping 12HP gain and loss of 7 Max TQ on a turbo'd RSX. Throttle response is slightly better.
Troy | May 6th, 2012
This TB is very well designed and crafted. After installing I noticed the butterfly hitting the manifold (would advise getting manifold bored and polished along with new injectors and kpro, if not then your A/F ratio will be off). It didn't bother me to lose the cruise control, I never used it anyways. The other issue is the EVAP valve, there is no were to mount it to this. So you may see about getting it shortened and tucked away nicely. Using a CAI, the short elbow is a pain to work with getting on but it will fit (barely). The instructions are a bit vague but there are a few DIY guides out there to help. There is a small idle set screw on the underside of the throttle spring that tends to loosen, I tightened it with some lock tight to prevent future problems.
Other than these few minor issues this TB is wonderful. Craftsmanship is next to none. I would buy again if I were to do it all over again.
Clinton | March 29th, 2011
Looks great, Easy to install, HP gains on contact, great throttle response! I gave 4 stars because 1. you loose cruise control, 2. have to buy a Type-S TPS sensor if you have a RSX Base. Other than that, its AWESOME!!!
omar simmons | April 5th, 2010
just put this on today, really wasn't hard at all. just remember to evenly tighten the bolts to the mani, otherwise the valve will pitch a fit. even using to stock intake manifold the added power is amazing, only draw back is losing the cruse control, but whit throttle response like this... youll never use it :)