Log In Cart
Log In

Create An Account

Log In Cart
Your Cart Is Empty
This part does not have vehicle specific fitment. Please contact us if you need assistance.

SpeedFactory Racing Burnt Titanium VTEC Oil Pressure Switch Delete
Part Number: SFR-02-056-B

Images may be for reference only

SpeedFactory Racing Burnt Titanium VTEC Oil Pressure Switch Delete
Part Number: SFR-02-056-B

Be the first to review!
Retail: $16.79
$15.95
Save: $0.84 (5%)

Earn 31 Builders Club Points. Learn More


Out of Stock
Enter your email address to be notified when it is back in stock.

Product Details

Part Number: SFR-02-056-B
Brand: Speedfactory Racing
Color: Titanium

SpeedFactory Racing Titanium VTEC Oil Pressure Switch Delete

Fits Honda / Acura B,D,F,H,J, and K-Series Engines

Whether utilizing one of our Street Series Cooling System Fill Pots, installing VTEC-Eliminating racing camshafts, or for aftermarket component clearance there are many reasons people rid their engine setups of the VTEC Oil Pressure Switch.Our ultralight, hollow-domed 6-point VTEC Oil Pressure Switch Delete bolts are machined from Ti-6Al-4V Titanium and are available in raw and burnt finishes. Each kit includes (1) bolt in finish of your choice. Simply remove your VTEC Oil Pressure Switch (If equipped) and install this bolt, re-using your factory O-Ring.

Please see OBD1 wiring notes below if necessary.

Wiring: Many common OBD1 and OBD2 JDM engines do not have a VTEC Oil Pressure Switch. The corresponding JDM ECUs for these engines do not use the pressure switch, so this will not be an issue. However, when using a USDM ECU on a JDM or USDM engine that does not have a VTEC Oil Pressure Switch, you will encounter a problem with VTEC not engaging because the USDM ECU will not be receiving the signal from the VTEC Pressure Switch.

The VTEC Oil Pressure Switch Wiring can be easily bypassed as follows:
  • 1) Locate the VTEC Oil Pressure Switch Plug on your engine harness (this wire comes from OBD1 ECU Pin D6).
  • 2) Simply TAP this wire into the VTEC Solenoid Valve Wire (the VTEC solenoid wire comes from OBD1 ECU Pin A4).
  • **Do not cut the VTEC Solenoid Wire (A4), simply connect the VTEC Pressure Switch wire to it.
  • 3) Your ECU will now believe that it has a VTEC Oil Pressure Switch connected and your VTEC will now function properly. 

WARNING: This product may contain chemicals known to the State of California to cause cancer or birth defects. www.P65Warnings.ca.gov.

Vehicle Fitment

This part does not have vehicle specific fitment. Please contact us if you need assistance.

Reviews ★★★★★ ★★★★★

No Reviews Yet!

Write a Review