Honda Genuine part 36172-P08-015 is a solenoid base gasket designed to seal the interface between a compatible solenoid base and its mating surface. A properly seated gasket helps maintain separation at the joint and supports clean, controlled reassembly when the specified solenoid assembly has been removed for service.

This is an individual replacement gasket, not a complete solenoid or gasket set. Confirm that the retained solenoid-base assembly calls for Honda part number 36172-P08-015 before ordering, particularly on engine swaps or modified vehicles where chassis identification alone does not confirm the installed assembly.

Features

• Genuine Honda solenoid base gasket.
• Honda manufacturer part number: 36172-P08-015.
• Designed as a direct-replacement service gasket for the specified solenoid base application.
• Provides a dedicated seal at the solenoid-base mating joint.

Additional Information

• Selling quantity is one gasket.
• Vehicle application must be verified against the retained assembly and the applicable parts catalog.
• A gasket should be handled carefully and kept free of dirt, oil residue, and damage before installation.

Common Reasons for Replacement

• Inspection finds the existing gasket flattened, torn, nicked, hardened, distorted, or otherwise unable to seat evenly.
• The solenoid base has been removed for diagnosis, cleaning, repair, or component access and the old gasket is unsuitable for reuse.
• Evidence of seepage is found around the joint after other possible sources have been inspected.

Installation Notes

1. Confirm part number 36172-P08-015 is specified for the installed solenoid base before disassembly.
2. Clean the mating surfaces carefully without scratching or gouging them; remove old gasket material and contamination.
3. Inspect the solenoid base and mating surface for damage, distortion, or corrosion that could prevent an even seal.
4. Position the gasket correctly without stretching, pinching, or folding it during assembly.
5. Use only the sealant, fastener sequence, and torque specifications stated in the applicable vehicle service manual.
6. After reassembly, inspect the joint for proper seating and check for seepage during normal operation.

Popular Performance Applications

Appropriate for maintenance, restoration, or engine-build work when a compatible Honda or Acura solenoid-base assembly is retained and verified to use this exact gasket. For swapped or modified vehicles, confirm the installed engine and solenoid assembly rather than relying on chassis fitment.

What's Included

• One Honda Genuine solenoid base gasket, part number 36172-P08-015.

Replace a compromised solenoid base gasket with the correct Honda Genuine service part to support a clean, properly sealed reassembly of the verified solenoid-base joint.