Free Shipping Over $299.99
Orders of $299.99 or more ship free within the continental U.S.
Shipping to Alaska and Hawaii is additional and not included.
We do not ship international at this time.
Acura RSX JDM Pedals Installation
Tools Required
- Power Drill
- Drill Bit (Smaller than the screws)
- Phillips head drill bit
- Phillips head black screws
- Flat head screwdriver
Step One
Remove the stock dead pedal using a flat tip screw driver. Install the JDM dead pedal using the stock clips.
Step Two
Remove the rubber covers over the brake and clutch pedals using the flat tip screwdriver.
Step Three
Drill out the screws that hold the JDM pedals to the stock mounting bracket (not shown). Put the JDM pedal onto the stock pedal and drill a hole through the stock pedal using the JDM pedal as a guide. Using the Phillips head drill bit, drill three screws into each pedal.
Step Four
Install the gas pedal and drill a hole on the top and the bottom of the pedal. Using the phillips head drill bit, install two screws into the holes you just drilled.
Step Five
Make sure all the screws are tightened down.