AEM Series 2 Plug & Play Engine Management System (J-Swaps)

AEM Series 2 Plug & Play Engine Management System (J-Swaps)
    Some images may be for reference only

    Review this product


     in stock
    Shipping Locations
    Michigan: 1 Available
    Pennsylvania: 1 Available
    Nevada: 1 Available

    Will It Fit Your Vehicle?

    This part should fit your vehicle. It is a universal part.


    AEM's Series 2 EMS is a complete engine control system that plugs into the factory harness and uses the factory sensors. This means you do not need to replace any parts of the harness or sensors, just plug the EMS into the harness and begin tuning! The Series 2 EMS allows you to control every aspect of your engine. From VTEC to rev limit, timing, adding different sized injectors, boost control, nitrous injection, even anti-lag and individual cylinder fuel and timing trims, the Series 2 EMS gives you total control from an easy to use interface.

  • Injector Outputs 10 Saturated
  • Coil Outputs 4
  • Selectable direct drive or 0-5V Coil Output
  • Direct plug in, no jumper harness required
  • General purpose LS outputs 11
  • General purpose HS outputs 4
  • Individual cylinder ignition trims
  • Individual cylinder fuel trims

  • Inputs
  • Trigger inputs (Ref/Sync) 4
  • Analog voltage inputs 14
  • Configurable Analog/RTD/Thermister inputs 4
  • Switch inputs 5
  • Lambda inputs 2x
  • Knock sensors 2
  • User adjustable knock sensor center frequency

  • Communication:
  • USB comms
  • RS232 comms
  • Communication cables included
  • Fully enabled editing/logging software included
  • CAN bus equipped
  • RS232 datastream output 19 ch
  • CAN datastream output 32 ch
  • Communicates with AIM Dash/Dataloggers
  • Communicates with Racepak Dash/Dataloggers

  • DATA Acquisition:
  • Internal data logging 1 MB
  • Maximum internal logging rate (per channel) 250 Hz
  • PC logging
  • Data analysis using AEMLog

  • Functions and Features:
  • All channels/maps/tuning options unlocked
  • Boost control
  • Groundspeed based boost target
  • Staged injection
  • Ground speed limiting
  • Rate of Acceleration Control
  • Overrun boost enhancement (anti-lag)
  • Gear change ignition cut (shift-without-lift)
  • Password protected calibrations
  • Fuel & Ignition rev limiters
  • "In cockpit" global fuel trim capability
  • Gear dependent shift light
  • Evap/Purge function
  • DC Motor control 2 Ch
  • Software definable "virtual" switch inputs 2
  • EGT Based fuel trims
  • Maximum boost limit None

  • Physical Dimensions:
  • Length 192 mm
  • Width 150 mm
  • Height 37 mm
  • Finish Black Anodized
  • Details

    Vehicle Fitment

    • Universal

    Product Reviews

    Be the first to review this product

    Add Your Review