KONI 02-06 RSX Type-S Yellow Front Shock
Images may be for reference only
The KONI Sport dampers are designed for aggressive driving or cars with suspension upgrades while continuing to offer comfort. If a KONI Sport is listed as an alternative to the KONI Special, choose Sport for aggressive handling characteristics. The KONI Sport (yellow) typically starts at a higher initial valving baseline to give a sportier feel and work on vehicles with higher performance parts. In some instances, KONI will only offer a Special or Sport valving and not both. Some modern cars come from the factory with higher tech suspension systems and wheel/tire packages so they would move directly into the Sport range, however they are still valved to give a comfortable ride with very good handling capabilities.
Modification of the front stock strut required for installation of these shocks: Click here to download the installation instructions
Sold as a single shock for the driver or passenger side. Typical order quantity is 2.
WARNING: This product may contain chemicals known to the State of California to cause cancer or birth defects. www.P65Warnings.ca.gov.
|Part Number:||8610 1415SPORT|
|Position:||Left or Right (Driver or Passenger)|
04-05 Civic Si Only (55mm O.D.)
2002 Acura RSX Automatic 2003 Acura RSX Automatic 2004 Acura RSX Automatic 2005 Acura RSX Automatic 2006 Acura RSX Automatic
2002 Acura RSX Manual 2003 Acura RSX Manual 2004 Acura RSX Manual 2005 Acura RSX Manual 2006 Acura RSX Manual
2002 Acura RSX Type-S 2003 Acura RSX Type-S 2004 Acura RSX Type-S 2005 Acura RSX Type-S 2006 Acura RSX Type-S
2001 Honda Civic Coupe 2002 Honda Civic Coupe 2003 Honda Civic Coupe 2004 Honda Civic Coupe 2005 Honda Civic Coupe
2001 Honda Civic Sedan 2002 Honda Civic Sedan 2003 Honda Civic Sedan 2004 Honda Civic Sedan 2005 Honda Civic Sedan
2004 Honda Civic Si Hatchback 2005 Honda Civic Si Hatchback
12 Reviews ★★★★★ ★★★★★
Currently Viewing Reviews with a rating of 5. Click here to reset.
4.50/5.00 Stars out of 12 ReviewsWrite a Review
5 Most Recent Read All 12 ReviewsRead All 12 Reviews
Jeff | April 19th, 2021
I put 2 of these on the front with the stock springs. Car rides great now, but here are the steps to install these so you can decide if it's worth it for you: -Remove wheels -unbolt brake line and speed sensors from strut -remove tie rods -remove 2 main strut bolts -pop hood and remove the 3 strut mounting bolts -pull out strut from car -use spring compressors on the springs -remove bolt holding strut together -pull out strut from the springs -drill a hole in the center of the top of the strut housing using 1/4 inch or smaller drill bit -drain strut fluid -mark a spot to cut the strut, 40mm from the bottom of the strut housing (instructions say subtract 6mm from the length of koni yellow bottoms to the portuding bumps on it which is 46mm in this case) -use tape to wrap around the strut on your mark to use as a cutting guide -cut off the strut housing with a saw on your marked spot -pull out oem damper -file down the edges on your cut -use 1/2 inch drill bit to widen the hole on top where you drained the fluid -insert koni yellow into your modified strut housing -use provided bolt in packaging and put through 1/2 inch hole on top and thread into koni -use ratchet to thread bolt to pull the koni all the way into place -remove the bolt and re thread it in the same spot with the provided crush washers -re install into your springs and put back in car And voila youre done. 12 hours later and 3 trips to auto zone and you should be finished. Maybe consider buying a fully assembled strut if that sounds like too much.
Steve | July 16th, 2012
Paired this with the Eibach prokit. I have them adjusted about 3/4s to full firm. Ride quality is great. My car is a dd and it's very comfortable. It's perfect for how I want it. Props to kseriesparts for exceptional service and fast shipping. I'll definitely be ordering from here again.......well I already have. Lol. Thanks for everything guys.
Colby | November 15th, 2011
I love my Koni Yellows, they are a terrific ride for my daily commute, where the roads are not exactly smooth. Paired with eibach springs, the ride is smooth enough to be usable and practical, while retaining good handling for the twisties.
Tu Pham | October 25th, 2011
these shocks are design for all of the lowering springs. I love them even we have to the mod for the front shocks on rsx. I would suggest these shocks for people who only have the lowering spring and don't have the koni yet. Great handling and comfort. Prebound is adjustable. By the way, the shipping package is missing the 2 plastic nuts that prevent from bottom out for the front shocks were missing. Other than that, i have nothing to downgrade for these shocks.
Tyler | June 17th, 2011
I purchased these along with the Einbach Pro-kit lowering springs. It gave a very nice drop that wasn't over the top. The adjustability feature on these shocks is very nice too.